# Sudarshan

Last seen: 19 dagen ago Active since 2017

Followers: 0   Following: 0

All

#### Feeds

View by

Submitted

Power Factor Correction (PFC) Boost Converter
PFC Boost Converter

Question

Power Supply current output for data analysis
Hello, We have many power supplies that have been running for the past 15 years. I have access to the power supply output curre...

bijna 2 jaar ago | 1 answer | 0

### 1

Question

Importing data from a .mat file into the Sensitivity Analyzer App on Simulink
I have a .mat file that has data that I would like to import into the Sensitivity Analyzer app on simulink to perform additional...

bijna 2 jaar ago | 1 answer | 0

### 1

Question

Capturing efficiency of a system while sweeping voltages and duty cycle parameters
I have a simscape simulation model of a power electronics converter and I need to find the optimum parameters to achieve the bes...

bijna 2 jaar ago | 1 answer | 0

### 1

Question

Modeling RG220 coaxial cable using a PI section line
I have two parallel RG-220/u coaxial cables which go to a magnet load from a pulse forming network. I recently found out that I ...

bijna 2 jaar ago | 1 answer | 0

### 1

Question

Extracting amplitude and frequency component using short time Fourier transform
I need to calculate the capacitance and equivalent series resistance (ESR) of a capacitor in a Boost converter. My boost convert...

ongeveer 2 jaar ago | 1 answer | 0

### 1

Question

Three-phase, three-winding transformer parameters
How to calculate the following values in a three-phase, three-winding transformer? I need to model this transformer in MATLAB/Si...

ongeveer 2 jaar ago | 0 answers | 0

### 0

Question

How to create a square wave with different amplitudes?
I need to generate a square wave from -8 to 15 with a frequency of 18 kHz. How can I do this in Simulink?

ongeveer 2 jaar ago | 1 answer | 0

### 1

Question

RC snubbers for 12-pulse thyristor bridge
I am trying to simulate an AC-DC power supply (12-pulse thyristor bridge connected in series) with an RC snubber. The real power...

bijna 3 jaar ago | 0 answers | 0

### 0

Question

Step Down Solar PV High DC Voltage
I have a PV panel which is rated at 5HP. The DC voltage generated by the panel is connected to the DC bus of its respective AC d...

meer dan 3 jaar ago | 0 answers | 0

### 0

Question

Computing voltage and current amplitude and average power
Hello, I have three sinusoidal waveforms namely, voltage, current, and power acquired using an oscilloscope which I then have c...

bijna 4 jaar ago | 1 answer | 0

### 1

Question

How to model a Klystron in Matlab/Simulink?
Hello all, I am trying to model a Klystron which is a specialized linear-beam vacuum tube that is used as an amplifier for high...

meer dan 4 jaar ago | 0 answers | 0

### 0

Question

How should the change in delta V (change in voltage) look like in a perturb and observe algorithm?
Hello all, I am currently working on an IEEE paper which is about extracting maximum power under partial shading of PV panels...

bijna 6 jaar ago | 0 answers | 0

### 0

Question

How do I plot this graph on MATLAB?
Dear all, I am having difficulty in plotting this particular graph on MATLAB. I know that I am supposed to use an if and/or f...

ongeveer 6 jaar ago | 1 answer | 0

### 1

Question

How to create a Network Node Incidence Matrix?
Hello guys, I am currently working on an IEEE paper which uses the Data of an IEEE-24 Bus System. I need to construct a Network...

meer dan 6 jaar ago | 2 answers | 0