photo

Franck Donnadieu


LPO R.DOISNEAU (Corbeil-Essonnes)

Last seen: 3 maanden ago |  Active since 2017

Followers: 0   Following: 0

Message

Statistics

All
  • Thankful Level 2
  • 5-Star Galaxy Level 1
  • Personal Best Downloads Level 1
  • First Review
  • First Submission
  • Thankful Level 1
  • First Answer
  • Revival Level 1

View badges

Feeds

View by

Answered
Rotationa to translation movement conversion - WITHOUT Simscape toolboxes
Hello, is this model is ok for you?

bijna 4 jaar ago | 1

Answered
Position control of DC motor in simple pendulum: The joint block will not accept output torque from motor?
Hello, you should Try to put a torque sensor between the DC Motor and the entry "T" of your joint.

bijna 6 jaar ago | 0

Question


How to insert a curve stemming from a measure in Simulink to use the parameter estimation?
Hello to all, I explain you briefly the problem with which I am confronted.I would like using the "Parameter estimation". This...

meer dan 6 jaar ago | 1 answer | 0

1

answer

Answered
How to measure Torque and RPM of a DC Engine at the same time in Simulink/Simscape
Good evening, I reproduced your model by adding a resistance. Try to separate scopes also. The overview of the results depends...

meer dan 6 jaar ago | 0

Question


SimMechanichs 2G works well but what the problem with Simscape Multibody?
Hello to all, I have a problem with the export from inventor2017 to MatlabR2017b while it works very well with R2014b. Par...

meer dan 6 jaar ago | 1 answer | 0

1

answer