photo

Supraja


Last seen: 7 dagen ago |  Active since 2024

Followers: 0   Following: 0

Statistics

  • First Answer

View badges

Feeds

View by

Answered
256QAM Rayleigh channel not able to locate 256 points in scatter plot Simulink.
Hello Sheeja, As far as I understand you are looking for a MATLAB resource to locate all the 256 scatter points of 256 QAM Rayl...

6 dagen ago | 0

Answered
Generate Low Frequency using ePWM module
Hello Arifin, I understand that you want to generate low frequency PWM for ePWM module for F28377D launch pad and not able to ...

7 dagen ago | 0

Answered
Distance measurement using TFmini-S in SIMULINK
Hello Gurpreet, I can infer from the question that you are using TFmini-S sensor and Arduino Uno board for distance measuremen...

ongeveer 2 maanden ago | 0

Answered
Can I use quadprog solver in an Explicit MPC?
Hello Dave, I can infer from the question that you want to use the 'quadprog' solver in explicit MPC. Yes, you can use it in a...

ongeveer 2 maanden ago | 0

Answered
I am using UV sensor and wanted the real time data to be exported to MATLAB in Real time. I need the continuous changes to be simultaneously noted
Hello Dayney, I understand that you are using Arduino for capturing the UV sensor data and would like to know about the real t...

2 maanden ago | 0

Answered
How to Pass Signal through canbus
Hello Youssef, I interpret from the question that you are trying to use CAN protocol and also you want to know about concatena...

2 maanden ago | 0

Answered
IEEE 802.15.4 ZigBee using SUN-FSK Modulation Technique
Hello Aditya, I understand that you are using Zigbee and FSK (Frequency Shift Keying) modulation. You are using MAC and PHY la...

2 maanden ago | 0

Answered
Including renewable generation in matpower for the ieee bus system
Hello, I understand that you want to add renewable generation value in matpower using any method other than adding as a negati...

6 maanden ago | 0

Answered
Kindly share the code to get plots of temporal response(displacement v time), average output power in the presence and absence of the tip mass, respectively.
Hello Mihir, I understand that you want to implement piezoelectric beam with the specified parameters. You can refer to the ...

6 maanden ago | 0