UAV Toolbox Support Package for PX4 Autopilots Error
1 view (last 30 days)
Show older comments
Whenever i try an Example simulation on my Pixhawk 1 i get this error. Any fixes?
Error occurred while executing External Mode MEX-file 'ext_comm':
Unexpected response from target. Expected EXT_CONNECT_RESPONSE.
Component:Simulink | Category:Block diagram error
Unable to connect to the 'PX4 Pixhawk 1' target for 'px4demo_Read_Parameter'
2 Comments
Ankur Bose
on 17 Nov 2020
Hello,
Can you confirm that you have run the PX4 Hardware setup screens and inserted an SD card to Pixhawk 1 with custom startup script as described here?
Also, please check that the Enable MAVLink checkbox in the Configuration parameters are not selected.
Ankur
Answers (1)
Remo Pillat
on 19 Jul 2024
Edited: Remo Pillat
on 19 Jul 2024
It has been a few years since this question was raised. If you still face errors or problems, please reach out to MathWorks Support, so we can take a closer look at your software and hardware configuration.
0 Comments
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!