alternate effect in simulink scheme

Hello, someone would know how to modify the simulink project that I am enclosing so that by means of some button or something that could be activated in the own scheme, the blocks that I mark with the red line would be eliminated and the input and output would be connected as I show with the green line.

The idea would be to be able to have these two schemes that I show next but only in one and that could be alternated from one to another by means of some button or similar

Answer 1

[Paul]

Generate both inputs into C2 and pass them through a Multi-Port Switch. Do the same for the inputs to the Scope. You can then set the Control Input to the Multi-Port Switches with an output from a Constant block with a parameter you set in the base workspace to select the configuration you want. This appraoch doesn't eliminate blocks from the diagram, but functionally achieves what you're looking for. If you really need to select the configuration with a button click, use a Manual Switch output as the control input to the Multi-Port switches. This approach will only work if you have only two configurations.

[Alejandro Fernández]

Could you please modify the simulink file I attached to the question?

I don't quite understand what you're saying.

[Paul]

Here's a simple example; perhaps you can adapt it to your needs:

[Alejandro Fernández]

Yes!!, that's fine for me :D. Thank you very much for everything.