how to control dc motor by matlab gui with adafruit motorshield V1?

4 views (last 30 days)
please help to control dc motor by matlab gui with arduino adafruit shield V1

Answers (1)

Tony Lennon
Tony Lennon on 9 Aug 2019
It's not exactly the same HW setup, but close.
  2 Comments
amin ya
amin ya on 10 Aug 2019
This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.
Madhu Govindarajan
Madhu Govindarajan on 12 Aug 2019
Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html
If you end up creating an add-on, please share with community using File Exchange.
Regards,
Madhu

Sign in to comment.

Communities

More Answers in the  Power Electronics Control

Categories

Find more on Arduino Hardware in Help Center and File Exchange

Products

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!