How to set up Altera Cyclone V SoC Development Kit for Embedded Coder Support Package?
9 views (last 30 days)
Show older comments
I have performed steps successfully until step 9 -connect the hardware
but matlab unable to connect the device using JTAG (time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Netanel
2 Comments
suneel kumar Gaddam
on 5 Dec 2016
I am not sure what the correct issue is here ? But can you try with USB UART connection?
Answers (1)
Wang Chen
on 8 Dec 2016
Edited: Wang Chen
on 8 Dec 2016
Hi Netanel,
Do you mean the serial connection (USB UART) is timing out?
Please set the jumper setting the same as the picture in page 12 of the board User Guide. Please make sure J28, J29, J30 is set the same as the picture.
https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature/ug/ug_cv_soc_dev_kit.pdf
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!