MATLAB Answers

C2000 ePWM block on Simulink to trigger two ADC channels?

3 views (last 30 days)
Solomon
Solomon on 25 May 2016
Edited: Solomon on 26 May 2016
I'd like to trigger two ADC channels on the F28377S Launchpad using Simulink, however, I do not know how to set up the ePWM block to trigger the ADCs one after the other but not at the same time. Can someone please guide me through the ePWM block parameters to achieve this?
Thanks!

  0 Comments

Sign in to comment.

Answers (1)

Sumith Sekharan
Sumith Sekharan on 26 May 2016
Hi Solomon, For F28377S processor there is no simultaneous sampling option. But you can achieve the same using 2 ADC modules. You can select the same PWM event trigger for both the modules. This should allow you to sample two channels with the same PWM event.
Hope this helps. Let me know.
Thanks, Sumith

  1 Comment

Solomon
Solomon on 26 May 2016
Hey Sumith, Using two different module works but I have quite a few sources that I want to read from and I don't have enough modules. Also, I'm not trying to sample them at the same time, but I'm trying to alternate sampling between both the channels so that they sample one after the other. This can be done using CCS but I'm a beginner and I would like to use Simulink to achieve the same. I'm pretty sure it has something to do with the ePWM block parameters.
Solomon

Sign in to comment.

Sign in to answer this question.