single phase and three phase dynamic load
8 views (last 30 days)
Show older comments
Hello all, My first question is why single phase dynamic load is not in simulink library? Another question, when i simulate single phase dynamic load in any mode(continuous,discrete or phaser)its too slow and if i run for longer time, the memory allocated for matlab is full and doesn't for forward. is there any solution for it? but this is not the case with three phase dynamic load. i am quit surprise with this.
is there any way to use three phase dynamic load for single phase dynamic load?
Many thanks
2 Comments
Tony Castillo
on 6 Nov 2015
Hey my friend I am having the same problem than you had in the past, could you share with my how did you surpassed it?, because i am mired with it. I would appreciate any the colaboration on it.
Sebastian Castro
on 6 Nov 2015
Edited: Sebastian Castro
on 6 Nov 2015
Tony: In case you missed it, I commented again on your question a few days ago.
Answers (2)
cr28
on 13 Aug 2012
Samir,
All i can say is when i simulated a 3-phase dynamic load in phasor mode, the simulation was quick.....a lot quicker than continuous mode.
0 Comments
See Also
Categories
Find more on Electrical Sensors in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!