Mismatch result in comparison operation in Simulink
1 view (last 30 days)
Show older comments
Hi,
I am doing comparision operation of two signals as shown fig 1. In one case, sine and triangular signals are compared whose result is shown in fig 2 and in other case sine, triangular signals are phase shifted by 180 deg, performed same operation as shown in fig3. Ideally, both results should be complement to each other , but observing spikes (shown in fig 3). What can be the reason for this ?. How to achieve ideal complementary responses ?.
Fig 1: Simulink circuit of comparision of two signals
Fig 2: Sine, Triangular comparision and its result
Fig 3: Sine, Triangular comparision with 180 deg phase shift and its result.
Simulation solver settings
0 Comments
Accepted Answer
Ganesh
on 29 Dec 2023
Edited: Ganesh
on 29 Dec 2023
I understand that you expect a flat line, complimenting Fig. 1.
However, the response generated seems to be consistent with the expected results. At T=0.005, the value of Sine Wave is equal to that of the Triangular Wave, and as you have allowed the parameter to be "less than or equal to", there is a spike.
You can try changing the block to be strictly lower than if you require a graph that compliments.
To help you understand, you could try to change the relational block to "greater than or equal to" with 0 phase and you will notice a spike in that figure too.
Hope this helps!
0 Comments
More Answers (1)
Sulaymon Eshkabilov
on 29 Dec 2023
The problem is caused by sine wave generator.
Try to tighten the sample time, e.g. 1e-9.
0 Comments
See Also
Categories
Find more on Specialized Power Systems in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!