How can I cascade N-port S-parameters using the RF Toolbox?
7 views (last 30 days)
Show older comments
I have a .s3p file with 3-port S-parameters that I would like to cascade into a network with 2-port S-parameters. I am unable to figure out how to put them together in the RF Toolbox.
Accepted Answer
MathWorks Support Team
on 27 Jun 2009
This enhancement has been incorporated in Release 2007b (R2007b). For previous product releases, read below for any possible workarounds:
The ability to cascade N-port S-parameters is not available in RF Toolbox. RF Toolbox only supports cascading of two port networks only.
However, RF Toolbox does allow reading and writing of N-port data files, but any analysis routines of this data must be provided by the user.
The following is an example of writing and reading N-port S-parameter files.
nports=42;
h=rfckt.passive
h.NetworkData.Freq = [1;2]*1e9
h.NetworkData.Data = cat(3,rand(nports,nports)+j*rand(nports,nports),rand(nports,nports)+j*rand(nports,nports))
analyze(h,h.NetworkData.Freq)
write(h,['test.s' num2str(nports) 'p'])
h2=read(rfckt.passive, ['test.s' num2str(nports) 'p'])
0 Comments
More Answers (0)
See Also
Categories
Find more on Data Import and Network Parameters in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!