Jung Sunghun

Last seen: ongeveer een jaar ago | Active since 2018

Followers: 0 Following: 0

www.uaslaboratory.com

Statistics

Feeds

Question

Too much varying signal output due to memory block
Hello all, This is Sunghun and I am currently trying to solve the too-varying signal output originating from using a memory blo...

bijna 2 jaar ago | 0 answers | 0

0

answers

Answered
How to scope and print UART data from STM32F4 evaluation board?
Dear Mr. Madhan Ravi, Thank you very much for your valuable comment. Based on your comment, I solved it by referring to the fo...

bijna 2 jaar ago | 2

| accepted

Question

How to scope and print UART data from STM32F4 evaluation board?
Hello all, I am currently struggling to find out how to scope and print out an array of hex data as shown below. It current...

bijna 2 jaar ago | 1 answer | 1

1

answer

Question

SIL error (Unable to find function)
Hello all, I am currently having trouble when I try to run the SIL simulation. As shown in the following capture, I simply crea...

bijna 2 jaar ago | 1 answer | 0

1

answer

Question

Need help on fixing Stateflow model.
Hello, I would appreciate if you help me on fixing my Stateflow model. I am currently building a Stateflow model to control t...

bijna 3 jaar ago | 1 answer | 0

1

answer

Question

Simscape "Boost Converter" not functioning as expected.
Hello all, I am currently trying to utilize a Simscape Boost Converter block to step-up incoming voltage from PV modules havi...

bijna 4 jaar ago | 1 answer | 0

1

answer

Answered
How to flip sign of discharging current in Simscape electrical circuit?
Nevermind. It seems that I misunderstood the problem...

bijna 4 jaar ago | 0

| accepted

Question

How to flip sign of discharging current in Simscape electrical circuit?
Dear all, I am currently trying to connect a battery pack and a supercapacitor in parallel to test each behavior while charge...

bijna 4 jaar ago | 1 answer | 0

1

answer

Answered
Question regarding a simple Simscape battery pack based model
I solved the problem. The problem was due to the connected motor model and I am currently investigating why..

bijna 4 jaar ago | 0

| accepted

Question

Question regarding a simple Simscape battery pack based model
Hello all, I am new to use the Simscape and have a question while I am building a battery pack based circuit as shown in the ...

bijna 4 jaar ago | 1 answer | 0

1

answer

Question

Error with the PV array simulation
Hello, I am currently trying to simulate a single PV cell which I bought from the following link (https://bit.ly/3CmLLeR). ...

bijna 4 jaar ago | 1 answer | 0

1

answer

Question

How to find all possible routes with a given node matrix?
Hello, I am trying to write a function to find all possible routes from the Start node, 6, to the Goal node, 21, with the giv...

meer dan 7 jaar ago | 2 answers | 0

2

answers