photo

ND


Span Pump Pvt Ltd

Last seen: meer dan 4 jaar ago |  Active since 2016

Followers: 0   Following: 0

Message

Statistics

  • First Review
  • Revival Level 1
  • First Answer

View badges

Feeds

View by

Question


I am using sawtooth generator, but does not give me zero slope, please help
I am using sawtooth generator, but does not give me zero slope, as i put phase and sampling time zero, only frequency is 100Hz.

meer dan 6 jaar ago | 0 answers | 0

0

answers

Question


Error in microchip SVM block used for PWM pulses generation
Currently I am working on motor control and using microchip motor block libaray for that, I am stuck to one block error unable t...

meer dan 6 jaar ago | 0 answers | 0

0

answers

Question


How to plot graph of power vs speed and Speed vs torque using below speed?
Good afternoon. I am trying to build graph of speed vs power and speed vs torque using below matlab code. I want graph for f...

meer dan 6 jaar ago | 1 answer | 0

1

answer

Answered
Plot multiple plots on the same graph
Can you please send full code with input file, I need this evulation file for my project, please share if possible inculding all...

meer dan 6 jaar ago | 0

Question


I want to build the simulink model for PMSM motor, which takes input from PWM high speed block of micro chip motor library.
Hello, I am buliding PMSM motor model using microchip library which i have to deploy on dsPIC33EP512 controller. So for that, I...

meer dan 6 jaar ago | 1 answer | 0

1

answer

Answered
Is there a code/command to execute/run 'Deploy to Hardware' (Matlab Simulink) in Matlab GUI?
is it possible to create gui for simulink model and then to deploy it on hardware ?????

ongeveer 8 jaar ago | 0

Question


To show multiple images on image viewer block on simulink according to the output execute
I am designing a image viewing system where image will be displayed according to the output obtained .. for example .. if output...

ongeveer 8 jaar ago | 0 answers | 0

0

answers