Community Profile

photo

William Knox


Last seen: meer dan 3 jaar ago Active since 2011

Professional Interests: control, signal processing

Statistics

  • First Review
  • First Answer

View badges

Content Feed

View by

Answered
Simulink to VHDL using VHDL Coder but "Data Type Conversion" blocks don't compile
To generate HDL code for a subsystem right-click on it and choose "Generate HDL Code for Subsystem". If you right click on th...

ongeveer 12 jaar ago | 0

Answered
Using non-memory-mapped (NMM) ports with FPGA-in-the-loop (FIL) cosim with XUP Atlys Spartan 6 Dev Board
Hi All, I found the solution. To manually create NMM ports perform the following steps; we will be creating a NMM port for th...

ongeveer 12 jaar ago | 1

| accepted

Answered
Digilent XUP Atlys Spartan 6 Development Board support in Hardware Co-Simulation
Hi All, I have found the solution. Xilinx University Program (XUP) provides a Hardware Cosim via point-to-point Ethernet plu...

ongeveer 12 jaar ago | 1

| accepted

Question


Digilent XUP Atlys Spartan 6 Development Board support in Hardware Co-Simulation
Hi, Does anyone know if The Mathworks plans to support the Digilent XUP Atlys Spartan 6 Development Board in *ethernet-based*...

meer dan 12 jaar ago | 1 answer | 0

1

answer

Question


Using non-memory-mapped (NMM) ports with FPGA-in-the-loop (FIL) cosim with XUP Atlys Spartan 6 Dev Board
Hi, I have a Digilent XUP Atlys Spartan 6 development board. FIL is supported with this board, however there does not seem to ...

meer dan 12 jaar ago | 1 answer | 0

1

answer