photo

S_Rajashree


Last seen: bijna 3 jaar ago |  Active since 2021

Followers: 0   Following: 0

Statistics

  • Thankful Level 1

View badges

Feeds

View by

Question


How to check mixer upconverted output at 2.4GHz?
I am using mixer to upconvert baseband signal of 1-2 MHz to 2.4GHz. I want to verify this upconverted signal before transmissio...

bijna 3 jaar ago | 1 answer | 0

1

answer

Question


Is it possible to install multiple MATLAB on ubuntu?
I am having R2021a installed in ubuntu and I have received a new trial license for R2021b. I want to install R2021b on Ubuntu(L...

ongeveer 3 jaar ago | 1 answer | 0

1

answer

Question


Oqpsk input to output mapping
I have used OQPSK block with samples per symbol as 2, phase offset as zero, input type- bit, symbol mapping- binary, output type...

ongeveer 3 jaar ago | 0 answers | 0

0

answers

Question


Randomness In AD9361 transceiver output
I run AD9361_QPSK testbensh multiple times. With each run the transmitter output and receiver outputs are different compare to t...

ongeveer 3 jaar ago | 0 answers | 0

0

answers

Question


Change centre frequency of "RF Blockset Models for Analog Devices RF Transceivers".
I am simulating Analog Devices RF AD9361 transmitter toolbox module. The design shown in Modelling and Simulating Analog Devices...

ongeveer 3 jaar ago | 0 answers | 0

0

answers

Question


how to open ad93xx_getdoc?
I need some documentation on how to use ad9361 tx rx and qpsk simulink model. There is not much information available. I found ...

ongeveer 3 jaar ago | 1 answer | 0

1

answer

Question


change center frequency for ad9361in simulink?
How to change the center frequency from 0 Hz to to 2.14GHz for AD9361 Tx model?

ongeveer 3 jaar ago | 0 answers | 0

0

answers