photo

yeyuan zhu


Last seen: meer dan een jaar ago |  Active since 2021

Followers: 0   Following: 0

Statistics

  • Thankful Level 1
  • First Review

View badges

Feeds

View by

Question


How can I avoid function duplication in code generation？
I wrote a corresponding .c and .tlc file for code generation to a Simulink s-function module. However, I found that as I have us...

bijna 2 jaar ago | 1 answer | 0

1

answer

Question


mex compiled error with garbled code
Hi, I am writing a c-mex function. At present, I have completed the writing of the. C file, but after compiling with the MEX in...

meer dan 2 jaar ago | 1 answer | 1

1

answer

Question


Can the code generated for 28388 ARM Core be opened in TI CCS?
Hello, recently developed 28388 ARM core through code generation, but found that the project file generated by code cannot be im...

meer dan 2 jaar ago | 0 answers | 0

0

answers

Question


Errors in "28388 TCP Send" modue code generation
Hello, I am using Simulink to generate C code and burn it to my DSP28388 to test Ethernet. The test program and code generation ...

meer dan 2 jaar ago | 0 answers | 0

0

answers

Question


Can 2021b Simulink's Matlab function module code be displayed in the Matlab editor?
Hello, THE matlab version I am using is 2021B. The code of matlab Function module of Simulink in this version is displayed in th...

bijna 3 jaar ago | 0 answers | 1

0

answers

Question


I can't connect my board in external mode (monitor&tune)
Hi, these days I have been reading the code generation examples of C2000 series provided on the official website, in which the f...

bijna 3 jaar ago | 0 answers | 0

0

answers

Question


ePWM TZ GPIO Pin Configuration for 28388
Hello, I met some problems in code generation when I was using ePWM module 28388 for TZ protection. The code generation error is...

ongeveer 3 jaar ago | 0 answers | 0

0

answers

Question


why need to plus one
Hi,I have a problem in code generation of ePWM module. I read the oficial routine of PMSM vector control, and see the TBPD in th...

ongeveer 3 jaar ago | 2 answers | 0

2

answers

Answered
28388D SCI_A received data is wrong
The result of the problem was to set the oscillator to 10MHz in the hardware configuration

ongeveer 3 jaar ago | 0

| accepted

Question


28388D SCI_A received data is wrong
Hi, I have a problem in 28388D SCI communication.the code picture are as follow,the program is transmit the data what you receiv...

ongeveer 3 jaar ago | 1 answer | 0

1

answer