Statistics
8 Questions
0 Answers
RANK
253.803
of 300.364
REPUTATION
0
CONTRIBUTIONS
8 Questions
0 Answers
ANSWER ACCEPTANCE
0.0%
VOTES RECEIVED
0
RANK
of 20.934
REPUTATION
N/A
AVERAGE RATING
0.00
CONTRIBUTIONS
0 Files
DOWNLOADS
0
ALL TIME DOWNLOADS
0
RANK
of 168.407
CONTRIBUTIONS
0 Problems
0 Solutions
SCORE
0
NUMBER OF BADGES
0
CONTRIBUTIONS
0 Posts
CONTRIBUTIONS
0 Public Channels
AVERAGE RATING
CONTRIBUTIONS
0 Highlights
AVERAGE NO. OF LIKES
Feeds
Question
Simulation run time vs. PC
I am looking into requesting a Simulation Workstation so my simulations run faster. I ran a comparison of total simulation time...
5 maanden ago | 1 answer | 0
1
answerQuestion
Need help - no motion using prismatic joint with pulley system
I have a simple telescoping tube model, where the linear motion is controlled by a pulley system. The drive pulley is powered u...
ongeveer een jaar ago | 0 answers | 0
0
answersQuestion
Multibody Error - Model not assembled - position violation
I have a multipbody model that involves an actuator moving linearly along a track (grey part in picture below). There are linka...
ongeveer een jaar ago | 0 answers | 0
0
answersQuestion
Use Multibody Spool component with only pulling force (can't push)
I have a Simscape Multibody model that uses a hydraulic winch to control the extension and retraction of a level arm. When exte...
meer dan een jaar ago | 1 answer | 0
1
answerQuestion
CAN BUS communication issue - ID number does not match setting
I am using a Kvaser USBcan Pro 1 device to communicate with a TI processor board. I am using the Vehicle Network Toolbox bloxks...
ongeveer 3 jaar ago | 1 answer | 0
1
answerQuestion
How to turn off MAT-file logging - option is greyed out
I am trying to optimize some code to be deployed to a processor board for testing. Running Code Generation Advisor, it suggests...
ongeveer 3 jaar ago | 1 answer | 0
1
answerQuestion
Trouble getting ADC to output signal with F280049C board
I want to use an ADC block to output a signal from a sensor interfacing a TI F280049C board, but I am having issues getting any ...
meer dan 3 jaar ago | 1 answer | 0
1
answerQuestion
How to setup SD Card Logging for C2000 target
I am working with a TI F280049C Launchpad and trying to set it up for external SD Card logging. I'm trying this example (https:/...
bijna 4 jaar ago | 0 answers | 0
