Embedded System
2 views (last 30 days)
Show older comments
How can we use Simulink to design our embedded system.. Can we interface MATLAB and Simulink with our Micro-controller and control its operation.. Is it possible... and How???
I am using PIC16F877A micro-controller...
0 Comments
Accepted Answer
Walter Roberson
on 5 Jun 2011
Also perhaps this MATLAB File Exchange Contribution: http://www.mathworks.com/matlabcentral/linkexchange/links/1303-embedded-target-for-dspic-a-matlab-toolbox-for-real-time-control-of-dspic-microcontrollers
(Note: I do not myself know if there is a difference between the dsPIC33 and the PIC16*)
4 Comments
Walter Roberson
on 5 Jun 2011
http://www.mathworks.com/matlabcentral/fileexchange/15955-read-lm73-temperature-sensor shows reading a temperature sensor using your chip.
And see these old practical notes:
http://www.mathworks.com/matlabcentral/newsreader/view_thread/45329
http://www.mathworks.com/matlabcentral/newsreader/view_thread/264868
Walter Roberson
on 5 Jun 2011
I'm think I might be missing something. The PIC16F877A only has 368 bytes of RAM. That would be very limited to use as a USB controller such as you mentioned in your previous post. Are you sure your USB controller is not communicating via serial emulation to the UART that is on-board the PIC16F877A ?
More Answers (0)
See Also
Categories
Find more on Startup and Shutdown in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!