How to save results

Hello everyone,

I have a very long Code that need much time to simulate, I want to the save all variables (it didn't finish the simulation) and I want to resimulate with the same variables saved to obtain the result of the code .

N.B: I create 3 functions and main in my code

Answer 1

[Walter Roberson]

One technique to do this is to convert your for loops into while loops, like this:

if exist('recover.mat')
    load('recover.mat');
else
    I = 1;
    J = 1;
    K = 1;
end

while I <= max_I
    while J <= max_J
        while K =< max_K
            do something
            K = K + 1;
            save recovery.mat
        end
        K = 1;
        J = J + 1;
    end
    J = 1;
    I = I + 1;
end
%when you get here you are done, so no need to set I=1

That is, instead of initializing the loop variables to 1 immediately like you would with

for I = 1 : max_I
    for J = 1 : max_J
    end
end

you continue on from whatever current values of I, J, K are active, and you do not reset those values until the end of the corresponding loop when you are setting up conditions for the next iteration of the enclosing loop.

If there is a failure, then the code should effectively end up restarting the computation from the beginning of the innermost loop iteration whose results were not already saved.

If some of the loops are short and fast you might not want to bother saving in the innermost, as saving takes time. You might, for example, want to move the save to after the J = J + 1, if the K loop is fast enough.

[Meriem Ben Kalia]

thank you