Why isnt it drawing the Rectangle?

Hello, I wrote a Script with Drawing Functions for use in later Projects. But I have a problem. If I call the function drawrectangle It is only drawing the left and the top line of the rectangle. I cannot find a solution for this problem. What is my mistake?

radius = 0;
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
function [] = drawcircle(radius,xincircle,yincircle)
  circle = 0:0.01:2*pi*radius; 
  xcircle = radius*sin(circle) + xincircle;
  ycircle = radius*cos(circle) + yincircle;
  plot(xcircle,ycircle);
end

function [] = drawline(linex1,liney1,linex2,liney2)
  linex = linex1:0.01:linex2;
  liney = liney1:0.01:liney2;
  plot(linex,liney);
end

function [] = drawpoint(pointx,pointy,thickness)
  scatter(pointx,pointy,thickness,'filled');
end

function [] = drawrectangle(cornerx,cornery,width,height)
  drawline(cornerx,cornery,cornerx+width,cornery);
  drawline(cornerx+width,cornery,cornerx+width,cornery-height);
  drawline(cornerx+width,cornery-height,cornerx,cornery-height);
  drawline(cornerx,cornery-height,cornerx,cornery);
end
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
xlim([-10,10]);
ylim([-10,10]);
axis equal;
hold on
%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%

drawcircle(1,0,0);
drawline(-10,-10,10,10);
drawpoint(0,2,100);
drawrectangle(-5,5,10,10);

%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%%
hold off

Small explanation of the Code: over the first % seperator, I define a variable that is needed in the draw circle function. Between the first and the second seperator are the functions. Between the second and third seperator I configure some parameters for the figure and there is the hold on command. Between the third and the fourth seperator I call the functions. This is the section where my later code will be written. After the last it is just the hold off command.

Answer 1

[Walter Roberson]

function [] = drawline(linex1,liney1,linex2,liney2)
  linex = linex1:0.01:linex2;
  liney = liney1:0.01:liney2;
  plot(linex,liney);
end

when you plot(), the length of x must be the same as the length of y. But since you are using a fixed step size, that would only happen if (linex2-linex1) is the same as (liney2-liney1) to within 0.01, which is not the case for you.

When you draw a straight line, you do not need to draw the intermediate points unless you want to put markers at them:

function [] = drawline(linex1,liney1,linex2,liney2)
  linex = [linex1, linex2];
  liney = [liney1,liney2];
  plot(linex,liney);
end

[dieter alfred]

Thank you very much. Now it is working.