Simulink : Get handle of a Matlab-Function block, inside Matlab-Function itself

Hello,

Is there a way to get handle of a Matlab-Function Simulink block inside of the Matlab-Function itself?

Thanks!

Answer 1

[Fangjun Jiang]

I would think so, just try handle=get_param(Block,'handle') where "Block" is the full path of the MATLAB function block in your Simulink model.

[langrg]

In fact I would like to get the handle OR the path of the block...

I want to know which block is linked to the Matlab-Function code executed.

[Fangjun Jiang]

would you try to see if "gcb" could always give you the correct path?

[langrg]

It works! I thougth that 'gcb' would change each time I select a bloc in Simulink, but in fact when it's used in Matlab-Function it always gives back Matlab-Function path.

I'm going to accept your answer and write solution in capital here:

USE "gcb" IS THE GOOD SOLUTION!

Thank you very much!