After loading the Simulink model to the pixhawk using the awsome 'Embedded Coder Support Package for PX4 Autopilots', I couldn't arm the motors and start the flight, I'm sure that there is something missing in the 'rc.txt' file in the SD card, but I do not know how to fix that, looking for your help. I can't start anything. I have no control of the pixhawk. Also some parameters are not loaded.
here is my rc,txt:
#Copyright 2018 The MathWorks, Inc.
# This is the custom rc.txt which loads px4_simulink_app on start-up
#nshterm /dev/ttyACM0 & #Disable the USB serial console
gps start # #gps start -f Starts GPS driver and Fake a GPS signal (useful for testing)
#Uncomment the below 2 lines to use LPE estimator
#Using EKF2 estimator by default as PX4 does build LPE on px4fmu-v2 due to a limited flash.
param load /fs/mtd_params
fmu mode_pwm # This is required for AUX PWM channels
#......... arming ....
mavlink start -d /dev/ttyACM0 -m config –x
nshterm /dev/ttyS6 & #this will make ttyS6 the serial console