PIL "rtiostream interface" timeout, f28377d, c2000

I am able to deploy code generation onto the DSP (f28377d controlCARD R1.1).

However I can't execute a Processor-in-the-loop simulation. The serial comms seems to be issue.

I get the below error after program has been downloaded to target.

Can I get some suggestions on how to troubleshoot the issue?

Thanks v. much

The timeout of 10 seconds for receiving data from the rtiostream interface has been exceeded. There might be multiple reasons for this failure.

You should:

(a) Check that the target hardware configuration is correct, for example, check that the byte ordering is correct.

(b) Confirm that the target is running.

(c) Consider the possibility of application run-time failures (e.g. divide by zero exceptions, incorrect custom code integration, etc.).

Note (c): To identify possible reasons for the run-time failure, consider using SIL, which supports signal handlers and debugging.

If you cannot find a solution, consider using the method setTimeoutRecvSecs of rtw.connectivity.RtIOStreamHostCommunicator to increase the timeout value.

[jinyu wang]

HI，i have the same problem,do you solve it?

[Meenakshi RM]

Hi,

May I know how you solved this problem?

Thanks,

Meenakshi

[MERIEM]

Ihave the same problem could any on e solve it

[YE]

Same here. How did you solve it?

[Michael Stellpflug]

I'll make another ticket, since OP may have died of covid

Answer 1

[Venkatesh Chilapur]

Hi,

Please contact :

https://www.mathworks.com/support/contact_us.html

Regards,

Venkatesh C