EMG acquisition sampling rate
5 views (last 30 days)
Show older comments
I am trying to capture EMG signal from Myoware muscle sensor and Arduino Uno , but my supervisor told me
that my sampling rate is too low ( only 50 Hz and x= 1x52, x is array of EMG and time ). He wanted my code to capture more data ( x = 1x1000) with
higher sampling rate ( ~ 1000 Hz), and he expect my program only run in 3 or 4 seconds
I am confusing with my result because Fs is high but data captured is not what I expect
Could you please help me ? Thanks a heap
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/217635/image.jpeg)
0 Comments
Answers (1)
Jingwei Too
on 12 May 2019
Normally, EMG signal is captured at the sampling rate of 1000 Hz since a lower sampling might not given you much valuable information. For example, you want to capture a signal of x with (1x1000). The '1' is the number of signal and the ''1000' is the number of samples. if you want to capture signal for 3 seconds, then you will get x with (1x3000). The number of samples is 3 second x 1000 Hz, so you get 3000 samples.
0 Comments
See Also
Categories
Find more on Spectral Measurements in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!