Temperature Control using PID via Simulink
11 views (last 30 days)
Show older comments
I found that after i insert PID parameters in the model, the lightbulb keep on flickering due to fluatuated duty cycle. Also, i found that no improvement is done using the PID parameters . Does this means PID dont have any function at all in improving the lightbulb performance? Theorectically, PID suppose is better than using ON/OFF and Deadband as it could reduce flickering. The results obtained is opposing the theory. Whats wrong with the model build as shown in Figure below?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/202514/image.png)
0 Comments
Answers (1)
Ege Keskin
on 3 Feb 2019
You might achieve better results by directly using the PID block on simulink.
0 Comments
See Also
Categories
Find more on PID Controller Tuning in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!