Error on Simulink for a xpc target
Show older comments
I have a xpc target and I am writing s functions in the simulink to load data and read data back from the add on card on the xpc target. When i am trying to connect to the xpc box and run the simulation after it gets connected i get this error:external mode open protocol start command failed.
I have a toworkspace block that is causing this. I am trying to read out 258 MB of data. Is this a limitation? what are the other ways to read out the data.
1 Comment
Kaustubha Govind
on 13 Jun 2012
Mohammed: It is possible that this is a bug. Perhaps you could try contacting MathWorks Tech Support about this?
Answers (0)
Categories
Find more on System Configuration in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
