Signal selection and coloring in "Simulation Data Inspector"
3 views (last 30 days)
Show older comments
Hello,
I'm logging several signals of my design but I only display a subset of them in Simulation Data Inspector by selecting and coloring them manually. When performing multiple runs of the same simulation for comparison, I want this subset of logged signals to be automatically displayed without selecting them each time. The repeated manual selection/coloring process is very time consuming. Is this automation possible ?
Kind regards, Jochen
0 Comments
Answers (1)
Raghul Gandhi
on 17 Dec 2018
I assume that you have checked certain signals of a run (Run 1) to be plotted in SDI. When you create a new simulation of the model, SDI moves the prior run (Run 1) to the Archive section. However, the view is preserved in the new run (Run 2). Any signals that were checked in Run 1 are automatically checked in Run 2.
The option to preserve the view can be accessed by clicking on the gear icon in the archive section header. More information can be found here.
0 Comments
See Also
Categories
Find more on Analyze Simulation Results in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!