c2000 embeded coder. f2978d simulink doubt

With c2000 embeded coder. I have made a simple simulink design, It always output the letter 's' no matter whatever constant is sent out to the SCI I have attached screenshot of the design

using f28379d launchpad as hardware

Answer 1

[Antonin]

Hi Varun,

The "protocol" mode is the culprit. It tries to establish communications using a proprietary protocol which is responsible for the 's' character being sent. In the configuration parameters of the model, under SCIA make sure to pick "Raw_data" for the communication mode. This should fix the problem.

I hope it helps,

Thanks,

Antonin.