Exportgraphics is not overwriting
37 views (last 30 days)
Show older comments
I have a set of figures that I'm saving using exportgraphics, after making some changes to the programm i get a new set of figures but exportgraphics is not overwriting it. I have been using this to export images for a long time and it used to overwrite, but since yesterday it isn't doing so. Any ideas about what may be causing this?
3 Comments
DGM
on 13 Jul 2024
Edited: DGM
on 13 Jul 2024
f2 = ""; % just for forum testing
filenameEN = fullfile(f2,"xyz.jpg");
x = 1:100;
y = 100:-1:1;
fig = gcf;
% i'm going to repeatedly plot and save the screenshot
for k = 1:3
plot(x,y)
fig.Units='inches';
fig.Position=[0,0,8,8.5];
exportgraphics(fig, filenameEN,'Resolution', 120);
imfinfo(filenameEN).FileModDate % check the timestamp
pause(3)
end
I'm not sure why the forum editor dumps the figure twice here, but all I'm looking for are the timestamps, which do change.
My point in testing this here on the forum isn't strictly demonstrative; it's simply that I run R2019b, which doesn't have exportgraphics(), so the forum is where I'd have to test it.
From my vantage point, I don't see a good reason why exportgraphics() wouldn't write the file, though I think there's probably an explanation that I simply can't see from where I'm at. For example, I've had scenarios where my file manager simply stopped updating the contents of the directory I was looking at. It might be worth trying to use imfinfo() as above to programmatically check the file for changes.
That said, I would hope that someone else can chime in with more insight on newer versions.
One last note which is completely unrelated to the main problem:
I strongly recommend using PNG for capturing line plots like this. JPG will produce a visually degraded copy and a larger file size than a PNG. Unless you need JPG for compatibility reasons, it's best avoided for simple synthetic images. Again, that shouldn't be affecting the file-overwriting issue at all. Just general advice.
Answers (1)
Sandeep Mishra
on 3 Sep 2024
Dear Vivek,
Upon running the code snippet in MATLAB R2022a, I noticed that the ‘exportgraphics’ function is working properly and overwriting the file when executed multiple times.
To address the issue, consider the following troubleshooting steps:
- Use the ‘clear all’ command to remove any existing variables that might interfere with your script.
- Make sure the file you are trying to overwrite is not open in another application, which can prevent overwriting.
Additionally, a practical solution can be to delete the existing file before exporting the new image.
You can achieve this with the following MATLAB code snippet:
if exist(filenameEN, 'file')
delete(filenameEN);
end
exportgraphics(gca, filenameEN);
I hope this helps.
0 Comments
See Also
Categories
Find more on Printing and Saving in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!