How to measure the output impedance of single-phase and three-phase inverters connected to the grid?
19 views (last 30 days)
Show older comments
Jefferson
on 25 May 2022
Edited: Subin Puthenkalam
on 28 Jun 2022
I need a method to measure the output impedance of single-phase and three-phase grid-connected inverters and then build the Bode diagram for the measured impedance.
Additionally, I am also interested in measuring the impedance seen by the grid.
The model I built was created in the following library: Simscape / Electrical / Specialized Power Systems
The schematic figure of the single-phase case is this:
0 Comments
Accepted Answer
Joel Van Sickel
on 13 Jun 2022
I would start with this block: https://www.mathworks.com/help/physmod/sps/powersys/ref/impedancemeasurement.html
but more generically, you can use the frequency response estimator tool in simulink control design to extract frequency response of your circuit as well. Here are some useful links if you want to look at more customizeable options:
Regards,
Joel
2 Comments
Subin Puthenkalam
on 28 Jun 2022
Edited: Subin Puthenkalam
on 28 Jun 2022
Hello Jefferson,
can you show how your impedance measurement result looks like?
Does it has resonance points?
Thanks in advance
More Answers (0)
See Also
Categories
Find more on Simscape Electrical in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!