How to use I/O mode to control a servo motor?

2 views (last 30 days)
Hello everyone, I am learning to use Arduino to control a servo motor. I successfully realized the this model, using external mode(run on the board), and the motor worked well. However, if I switch to I/O mode(run on the computer), the motor won't move at all. What other settings should I do?
I have another program that is too large to run on the board, so I want to try I/O mode first in this simple example. Any reply is welcomed. Thank you!

Accepted Answer

Arun Kumar
Arun Kumar on 3 Jun 2022
Hi Cong Sun,
Not all the block support connected IO mode.
The blocks that support this IO mode are listed in the following page:
Other blocks which are not listed in this page will output 0s if you try to run in connecte IO mode.
Hope this helps!
Thanks,
Arun
  6 Comments
Cong Sun
Cong Sun on 24 Jun 2022
Dear Kumar
Thank you for the reply. I think I will try another way. Do you have plan to enrich the functions of Connected IO mode? Have a nice weekend!

Sign in to comment.

More Answers (0)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!