Regenerating training verbose table from saved traininfo

9 views (last 30 days)
i trying to regenerate verbose table as shown below from the traininfo that i saved earlier after finish running the model.
However, when i treid to tabulate the data from traininfo using struct2table i get the following table which is completely different from original verbose table that we got after finish training the model in matlab.
Hope someone could share some help on contructing the same verbose table as the shown in the first figure. Thank you very much.

Accepted Answer

yanqi liu
yanqi liu on 13 Dec 2021
yes,sir,if you want save the command information,may be use
diary on;
run your code
diary off;
finally,you will get log file,it save the command information
yanqi liu
yanqi liu on 13 Dec 2021
yes,sir,the loss NaN is common during train steps
may be the input data、learn rate and so on
for more information,may be check,function%20domain%2C%20then%20determine%20what%20those%20inputs%20are.
Teo on 13 Dec 2021
Thank you very much @yanqi liu for your explaination. It helps a lot.

Sign in to comment.

More Answers (0)




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!