Why I cannot make the BNO055 fully calibrated?
9 views (last 30 days)
Show older comments
Hi all,
I connected an Adafruit BNO055 to the host pc with an Arduino Nano3. I used "MATLAB Support Package for Arduino Hardware" and follow the document "Read and Plot Real-Time Data from BNO055 Sensor in NDOF Mode". When I tried to calibrate the imu, I can never make the system status to 'full' while others (accel, gyro, and mag) are 'full'. Because of that, I cannot use any functions that work in 'ndof' mode as those require a fully calibrated system.
Appreciate for any advice.
Best Regards
0 Comments
Answers (1)
Rohan Kale
on 11 Nov 2021
Hi Linxin,
Refer to the calibration steps documented at
Once the BNO055 is fully calibrated, you should be able to come out of the while loop in the "Calibrate BNO055 Sensor" section on the page "Read and Plot Real-Time Data from BNO055 Sensor in NDOF Mode"
You may also consider using a longer USB cable to facilitate the calibration process
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!