MATLAB Answers

Sameer
0

How to change FFT settings ?

Asked by Sameer
on 26 Jun 2014
Latest activity Commented on by Sameer
on 10 Jul 2014
I am analyzing a power system simulated on SIMULINK for which I need to use some FFT tool. Usually, the "Powergui" is used to get the FFT of a signal. However, when I use it I do not get specific frequencies that are present in the signal. The results display all the frequencies depending on the number of cycles I select and the frequency. Also, when I use the "power_fftscope" function, the fundamental frequency has been preset to 60 Hz; I want to change it to 50 Hz. Could you guys help me out in atleast one of the two problems mentioned above?

  0 Comments

Sign in to comment.

1 Answer

Answer by Rashmil Dahanayake on 26 Jun 2014
 Accepted Answer

Are you using the Gui of the fftscope.
If so you can update the number of cycles and frequency as required. If you need only integet multiples of the fundamental, set number of cycles to 1.
In command line you, need to initially store fft results to a structure then modify the parameters(fundamental, cycles) prior to the second run.

  1 Comment

Sameer
on 10 Jul 2014
How do I store the FFT results? Can i use a MATLAB code to get the frequencies in this signal?

Sign in to comment.