How to trim the non-manifold triangle off the stl file?
5 views (last 30 days)
Show older comments
Hi everyone
I have a question about the 3D stl file processing.
Suppose that I have the 3D geometry (stl file).
I use stlread and trimesh command to plot it, then I found that some of elements are non-manifold.
I try to directly remove these two triangule faces for about entire afternoon, but I haven't done it succefully yet.
Could any one give me some suggestions?
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/594020/image.jpeg)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/594025/image.jpeg)
Attached is the stl file, to view the stl file, with the codes as below:
fv=stlread('test.stl')
figure();
trimesh(fv);
axis equal
0 Comments
Answers (1)
Bruno Luong
on 23 Apr 2021
There is SW that can detect topology issue and attempt to correct it, such as
0 Comments
See Also
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!