I can't solve errors from output error status of creating PWM signal(example of Embedded coder support package for PX4 autopilot)

Hi, I'm trying to make PWM signal from my px4 hardware(Pixhawk1) with the example 'Getting Started with PWM Blocks for PX4 Autopilots' from Embedded coder support package for PX4 Autopilot.

I executed the example(monitor and tune), however, the output error status of PWM block indicated my error states.

I found the meanings of the error, however, I can't how to fix them.

How can I find solutions of my errors?

[David Fink]

It sounds like you found the error code table on this page:

https://www.mathworks.com/help/supportpkg/px4/ref/px4pwmoutput.html#mw_2edf5414-fcb1-411f-b4e6-6c8d354ca4b8

If that doesn't help, reach out to MathWorks Technical Support for assistance.

[lim daehee]

This is becuase I didn't calibrated my RC transmitter.. The example works well after calibration.

Thank you for your reply. :)

Answer 1

[Arun Mathamkode]

As per your discription the issue is resolved after caliberating the RC transmitter. I am just reposting it as an answer so that it helps anyone who may be looking for this issue. .