How can I efficiently down-sample data that is non-uniformly spaced?
10 views (last 30 days)
Show older comments
Martin Hoecker
on 17 Sep 2012
Commented: Paul Quelet
on 15 Oct 2014
I am working with long time-series. My data acquisition system takes one point per second for months - except when it hangs for a few minutes or hours, then there will be no data for this time interval.
I want to down-sample this data to say one point per 60 seconds. However, because there can be "gaps" in the data, I am struggling to find efficient code for this!
I tried the following approach for a typical array (called "data") that holds 0.5 million rows and two columns: The first column is the time, the second column is the actual data.
start_time = data(1,1);
end_time = data(end,1);
time_step = 60/(3600*24);
total_time = end_time - start_time;
% Prepare the downsampled data array.
downsampled_data = zeros(floor(total_time/time_step),2);
tic
for i = 1:length(downsampled_data)
% For each time intervall, find all points in this intervall, and
% average over them
downsampled_data(i,1) = start_time + (i-0.5)*time_step;
downsampled_data(i,2) = mean(data(data > start_time + (i-1)*time_step &...
data < start_time + i*time_step,2));
end
toc
As a final step I would have to fish out those points where there is no data... However, the above code takes about 60 seconds to run for .5 million points - and I need it to run in less than 10 minutes for an array of 5 million points. Can you guys think of a way of speeding it up?
1 Comment
Paul Quelet
on 15 Oct 2014
Thank you for posting this algorithm.
The code is very helpful in something that I am doing. However, when I used it for my dataset, I ended up with some values on the exact hour with 00:00 for the minutes and seconds, which became NaN . In any case, I would revise the above algorithm to include the equal to condition, in my case at the bottom time:
mean(data(data >= start_time + (i-1)*time_step &...
data < start_time + i*time_step,2));
Many thanks again for the algorithm Martin and fast solution Andrei.
Accepted Answer
Andrei Bobrov
on 17 Sep 2012
[Y, M, D, H, MN] = datevec(data(:,1));
[c,c,c] = unique([Y, M, D, H, MN],'rows');
out = accumarray(c,data(:,2),[],@mean);
More Answers (0)
See Also
Categories
Find more on Multirate Signal Processing in Help Center and File Exchange
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!