Revolute robot arm by a certain angle (degrees)
3 views (last 30 days)
Show older comments
Hi All I am trying to simulate the UR-10 robot arm in simscape. I was able to build the robot arm
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/168068/image.jpeg)
and add the Revolute Joints
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/168070/image.jpeg)
. I need to Revolute specific joints with a specific angle(30 and 60 degrees) I am not sure how to do that, can anyone help?
0 Comments
Answers (1)
Prashant Arora
on 18 Oct 2017
Hi,
I am assuming that you are looking to specify initial state positions for the revolute joint. This can be done in the "State Targets" property of the block. You can check the "Specify Position Target" and "Specify Velocity Target" to specify initial position and velocity. You can read more about this at the following link:
Hope this helps!
0 Comments
See Also
Categories
Find more on Manipulator Modeling in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!