how can we call a scope to workspace witout opening the model file?
2 views (last 30 days)
Show older comments
in my project, i ve designed an active power filter using model file. In that for optimization of parameters, i ve used an algorithm. This model file is being called to the m-file(algorithm). Here i need a suggestion to compile the algorithm without opening the model file (i.e.,) only the scope should be viewed. with regards, shanthi.
0 Comments
Answers (2)
Roshin Kadanna Pally
on 8 Mar 2012
You can save your model with Scopes closed. Then do the following:
load_system('modelName');
open_system('modelName/scopeName');
To compile the model (I assume this will also compile your algorithm):
set_param('modelName', 'SimulationCommand', 'Update');
This will not send data to the Scope. To view data on Scope, simulate the model using sim command. The model remains closed.
0 Comments
Andreas Goser
on 7 Feb 2012
In my view, you can run the simulation with the SIM command, but not open the scope. However, you can use the simulation data to plot the result in a MATLAB figure, that looks pretty much the same (compared to the scope).
0 Comments
See Also
Categories
Find more on Introduction to Installation and Licensing in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!