How can I change the nominal power of the generator (DFIG and SCIG) during simulation ???

my project is depend on changing the nominal power of the generators, transformer and loads during simulation But when I do it with command set_param error appear, the error is {Cannot change parameter of generator while simulation is running.) I want to change the nominal power of these block espically generators. How can I overcom of this error??????. thanks a lot

[yk tu]

i also want to know

Answer 1

[Sabin]

It is not possible to change all parameters during runtime. You can use fast restart and avoid recompiling the model but there is no way to change the nominal parameters during simulation.