Problem with external mode and model running on target hardware
6 views (last 30 days)
Show older comments
Graham Cotgreave
on 3 Oct 2022
Commented: Graham Cotgreave
on 11 Sep 2023
When attempting to connect a model running on the target hardware I encounter "External mode simulation is not supported for models with local messages."
I can't find anywhere in the documentation that describes how to send messages within a state chart without using "local message". Neither can I find this limitation listed under the "External Mode" settings when running on hardware.
Does anyone have any advice?
0 Comments
Accepted Answer
Yoga
on 10 Sep 2023
I understand that you are unable to connect a model running on your target hardware.
Local messages in Stateflow charts are used for communication between different states or components within a chart and are not designed to be exchanged with the external environment or hardware. If you can eliminate the use of local messages within your Stateflow chart, this would be the easiest solution. Try to use other Stateflow constructs like events, data, or transitions to achieve your desired behavior without local messages.
I hope this helps resolve your issue.
More Answers (0)
See Also
Categories
Find more on Simulink Functions in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!