2 arduino connect in simulink

3 views (last 30 days)
JAE HONG LEE
JAE HONG LEE on 24 May 2022
Answered: Amish on 5 Feb 2025 at 4:47
Hi. I have some problem in my mobile robot project.
I useing controller arduino mega 2560 and control 4 DC motorl. unfortunately arduino mega only have 3 interrupt pin than i can't read 4 motrol encoder siganl in my robot. than i using two arduino mega but i can't connect arduino to arduino in simulink.
so anyone solve this problem please tell me.....

Answers (1)

Amish
Amish on 5 Feb 2025 at 4:47
Hi Jae,
You can control 2 Arduino blocks to Simulink by using the Master-Slave Architecture to ensure both boards can communicate effectively and work together to control your robot's motors and read encoder signals.
You can have a setup where the two Arduino's are connected using an I2C communication protocol. This way, the Master Arduino can initiate communication and request data from the Slave Arduino where as the slave respond to requests from the Master Arduino with the Encoder data.
The Master can then be used to control the motors. Connect three encoder signals to the available interrupt pins. For the Slave Arduino, use this to read the fourth encoder signal and any additional sensors or inputs.
The Simulink setup would involve using Arduino Support Package in Simulink to configure each board. You may create a single model with two distinct sections for each board.
Also, make sure that each Arduino has a unique I2C address to avoid conflicts and that the data transfer between the two Arduinos is synchronized, especially if the data is time-sensitive.
For more information you can refer to the documentation for the Arduino Support Package : https://www.mathworks.com/hardware-support/arduino.html
Hope this helps

Products


Release

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!