Optimtool for nonlinear constrained optimization - Bounds on design variables
1 view (last 30 days)
Show older comments
Hello,
i am using Optimtool for nonlinear constrained optimization.
After writing down two separated files for the objective function and the set of nonlinear constraints, it must be indicated also the lower and upper limits for each of the n-design variables x(1),x(2),...,x(n).
Suppose that x(1) [0.001, 0.05]; and x(2) = [0.7,2];
How one should indicate this? is is correct to write: lb =[0.001, 0.05] and ub = [0.7 2] ?
thanks
0 Comments
Accepted Answer
More Answers (0)
See Also
Categories
Find more on Problem-Based Optimization Setup in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!