How do i solve the following simulation error??
15 views (last 30 days)
Show older comments
When i run a physical model of half wave rectifier in simulink it shows the error for the solver block...
'Calculation for differential and algebraic state derivatives failed.'
How do i solve this??
1 Comment
Accepted Answer
Zack Peters
on 24 Oct 2013
Hi Paranshu,
It is hard to say based on the information that is provided but it may be due to several reasons. Internally, the Simscape blocks have differential equations that represent each of them. If the equations were not strongly written in the case of a custom block then this error can appear sometimes. Additionally, the solver may be limited to being unable to solve these type of equations. Try reducing changing the solver to either ODE15s or ODE23t and reducing the Absolute/Relative tolerances in the configuration parameters to 1e-6.
Does this model use any custom Simscape components and does it error out immediately or somewhere midway through the simulation?
~Zack
4 Comments
MANNIKA GARG
on 2 Feb 2017
Hi Paranshu, How did you solve this. I am observing the same problem with my simulations. No custom block have been used.
More Answers (0)
See Also
Categories
Find more on Variable Initialization in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!