MPC Signal Types
For MPC design purposes, signals are usually categorized into different input and output
types. Typically you use
setmpcsignals to specify, in your plant model,
whether an input or output signal belongs to one of the following categories.
The plant inputs are the independent variables affecting the plant. As shown in MPC Prediction Models, there are three types:
The controller cannot adjust them, but uses them for feedforward compensation.
The controller adjusts these in order to achieve its goals.
These are independent inputs of which the controller has no direct knowledge, and for which it must compensate.
The plant outputs are the dependent variables (outcomes) you wish to control or monitor. As shown in MPC Prediction Models, there are two types:
The controller uses these to estimate unmeasured quantities and as feedback on the success of its adjustments.
The controller estimates these based on available measurements and the plant model. The controller can also hold unmeasured outputs at setpoints or within constraint boundaries.