Answered
I try to write simple analytical function Gomez and Levy with ga in optimization toolbox but it cannot run
Hi Sogol, When I try to reproduce the issue at my end I encountered the error as Function definition not supported in this cont...

ongeveer 2 jaar ago | 0

Answered
Lowpass filter with own cutoff frequency and y axis in dB.
Hi Reji, I understand that you are trying to implement a low pass filter. Using the "lowpass" command in MATLAB output signal ...

ongeveer 2 jaar ago | 0

Answered
Please How do I extract data from a struct
Hi osemudiamen oriabure, I understand that you are trying to convert a struct variable to a table and then merge it with anothe...

ongeveer 2 jaar ago | 0

Answered
Error using InputOutputModel/feedback (line 137)
Hi Tenzing, From my understanding, you are trying to give positive feedback to your system and gain of feedback block is one. ...

meer dan 2 jaar ago | 1

Answered
Calculate variablity over specified interval and apply corresponding calculation back to formula
Hi Daniel, When we apply a logical condition on an array(Y) it will produce logical array, by giving this as an index to ano...

meer dan 2 jaar ago | 0

| accepted

Answered
i am not getting chaotic plot because of warning
Hi Pratyusha, In case of sharp discontinuities in the reference input, it is possible that this warning is generated at interm...

meer dan 2 jaar ago | 0

Answered
I am getting an extract error message while trying to install matlab
Hi Nnamdi, Go through the following link which helps in eliminating the error. https://www.mathworks.com/matlabcentral/answers...

meer dan 2 jaar ago | 0

Answered
Unable to perform assignment because the indices on the left side are not compatible with the size of the right side.
Hi Yineth, From my understanding, at every iteration the code produces more than one solution for X. So, storing the output in...

meer dan 2 jaar ago | 0

Answered
Finding Frictional Pressure Drop in a Gas system through Simscape object Pipe(G)
Hi Abhishek, From my understanding, you are trying to find the pressure difference caused by pipe due to friction. This...

meer dan 2 jaar ago | 1

Answered
How to find output of system with impulse response function
Hi Mandeep, From my understanding you are trying to find output of the system which can be obtained by convolution of input an...

meer dan 2 jaar ago | 1

| accepted

Answered
how can I write this exponential function in MATLAB?
Hi Ayushman, You can use exp() function in the MATLAB. Refer to the below example for x=0:3 u=exp(-16*(x-1/2)^2)*sin(zet...

meer dan 2 jaar ago | 0

| accepted