[Simulink] I want to just switch two values with positive trigger
9 views (last 30 days)
Show older comments
Hi,
I want to make a simple Simulink model, switching two values with positive trigger, as shown below.
How can I make it? I tried many things, but I could not.
# I want to use only HDL-compatible block.
Best,
0 Comments
Answers (1)
Fangjun Jiang
on 5 Oct 2022
Use the trig signal to trig a "triggered subsystem", the trigger type is "rising". Inside the subsystem is a "Not" logical block. Outside, feed the subsystem output to a "Unit Delay" block and then feed it to the input of the subsystem. Set the inital of "Unit Dela" to be 0.
All blocks are from HDL library.
0 Comments
See Also
Products
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!