Conversion of Simulink Model to previous version

7 views (last 30 days)
I have my models saved in 2020b version
Requsting the community members to support me for 2015a version

Accepted Answer

Jesús Zambrano
Jesús Zambrano on 4 Oct 2021
Go to the Simulation Tab and do:
Then, select the release version:
  3 Comments
Jesús Zambrano
Jesús Zambrano on 5 Oct 2021
Hey Siva, here you are.
Seems that exporting the RLC_Circuit model was OK, but the Noise_Filter model was partially converted. The error message says:
Block of type "dsp.LowpassFilter" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.
Block of type "SpectrumAnalyzer" uses functionality that is not available in Simulink R2015a and has been replaced with an empty subsystem.
That's all I can do for you at this point. Otherwise, get R2020b! :-)
I suggets you contact the designer of those models and check the setting used for those two blocks, so you can run the model in R15a.
Best,
Jesús
Siva Murugesan
Siva Murugesan on 6 Oct 2021
Hello Zambrano,
That's a bit to worry but thanks to you.
I will be able to take this further.
Thank you once again.
Regards,
Siva

Sign in to comment.

More Answers (0)

Categories

Find more on Programming in Help Center and File Exchange

Tags

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!