Configure XCP slave connection
Simulink Real-Time / XCP / CAN
Vehicle Network Toolbox / XCP Communication / CAN
The XCP CAN Configuration block uses the parameters specified in the A2L file and the ASAP2 database to establish an XCP slave connection.
Before you acquire or stimulate data, specify the A2L file to use in your XCP CAN Configuration. Use one XCP CAN Configuration to configure one slave connection for data acquisition or stimulation. If you add XCP CAN Data Acquisition and XCP CAN Data Stimulation blocks, your model checks to see if there is a corresponding XCP CAN Configuration block. If there is no corresponding XCP CAN Configuration block, the model prompts you to add one.
The XCP CAN communication blocks support Simulink® accelerator mode and rapid accelerator mode. You can speed up the execution of Simulink models by using these modes. For more information about these simulation modes, see Design Your Model for Effective Acceleration (Simulink).
The XCP communication blocks support code generation with limited deployment capabilities. Code generation requires a C++ compiler that is compatible with the code generation target. For more information, see Supported and Compatible Compilers.
Config name— Specify XCP CAN session name
Specify a unique name for your XCP CAN session.
A2L File— Select an A2L file
Click Browse to select an A2L file for your XCP CAN session.
Enable seed/key security— Select that key required to establish connection
Select this option if your slave requires a secure key to establish connection. Select a file that contains the seed/key definition to enable security.
File (*.DLL)— Select file for seed and key security
If you select Enable seed/key security
EnableSecurity), this field is enabled. Click
Browse to select the file that contains the seed
and key security algorithm that unlocks an XCP slave module. This parameter
is available in Windows Desktop Simulation for Vehicle Network
Output connection status— Display connection status
Select this option to display the status of the connection to the slave module. Selecting this option adds a new output port.