Main Content

Deployment

Build the model that loads and runs an executable on the target hardware

How to deploy Simulink® models and interact with Xilinx® Zynq® Platforms connected to your development computer.

Simulink Configuration Parameters

Model Configuration Parameters for Xilinx Zynq ZC702/ZC706 Evaluation Kits
Model Configuration Parameters for Xilinx Zynq ZedBoard

Topics

Setup Xilinx Zynq Platform and Software

Install Xilinx software and set up the hardware.

Build and Run Executable on Xilinx Zynq Platform

Build and run executable on Xilinx Zynq platform.

Stop or Restart Executable Running on Xilinx Zynq Platform

Stop or restart an executable running on Xilinx Zynq platform.

Host-Target Communication with External Mode Simulation

Tune parameters and monitor signals through communication channel between development computer and target hardware.

External Mode Simulation by Using XCP Communication

Run external mode simulations that use an XCP communication channel.

External Mode Simulation with TCP/IP

Run external mode simulations that use a TCP/IP or serial communication channel.

Troubleshooting

Get IP Address of Xilinx Zynq Platform

You can get the IP address of the Xilinx Zynq platform from the MATLAB® Command Window or using the Linux® command line.

Command Line Session with Xilinx Zynq Platform

Open a serial command-line session with Xilinx Zynq platform.

Featured Examples

Parameter Tuning with External Mode Simulation

Parameter Tuning with External Mode Simulation

Run a Simulink® model in external mode on an ARM Cortex-A processor in a Xilinx® Zynq® platform.

Open Live Script
Communicate with the Programmable Logic IP Core on Xilinx Zynq Platform Using AXI4-Lite Protocol

Communicate with the Programmable Logic IP Core on Xilinx Zynq Platform Using AXI4-Lite Protocol

Communicate with the programmable logic IP core on Xilinx® Zynq® platform by using the Advanced eXtensible Interface 4 Lite (AXI4®-Lite) protocol.

Open Live Script
Field-Oriented Control of a Permanent Magnet Synchronous Machine

Field-Oriented Control of a Permanent Magnet Synchronous Machine

Model a controller and implement it on a Xilinx® Zynq™-7000 All Programmable SoC target. This example uses a ZedBoard with an Analog Devices® motor control FMC board. If you do not have the required hardware, you can use this example to help you develop a controller for your own hardware configuration.

Open Live Script

Embedded Coder Support Package for Xilinx Zynq Platform Documentation

Support

10 Best Practices for Deploying AUTOSAR Using Simulink

10 Best Practices for Deploying AUTOSAR Using Simulink

Download guide